HOW TO WIRE THE DENSO ALTERNATOR - Ural
Here at Crawford Sales we noticed that
step 4 of the supplied instructions was
perhaps not as clear as we'd like. We
hope this revised procedure helps.
#1: Connect the two ring type eyelet
connectors to the top post connector.
That's the simple part.
#2: Connect the existing green spade
type connector to the left (horizontal) of the
two terminals on the back of the
alternator.
#3: Now, you've got that new red pigtail to
hook up. Look for the ignition power wire
coming out of the top of the front ignition
cover. Follow it back a few inches to the
black plastic connector. Pull it apart.
Plug in the short female connector to the
wire coming out of the ignition cover, and
plug the male connector into the main
wiring harness side. Now, run the long
red wire and attach it to the right side
(vertical) connector on the back of the
alternator, right next to that pretty green
wire.
Congratulations, you're wired!
This Page was last updated: Monday, April 21, 2008 at 1:07:22 AM
This page was originally posted: 11/7/04; 10:28:56 AM.
Copyright 2008 CRAWFORD SALES COMPANY
|
